Netopia R7200 - Manual (Page 157)

Security 14-7
A filtering rule
The criteria are based on information contained in the packets. A filter is simply a rule that prescribes cer tain
actions based on cer tain conditions. For example, the following rule qualifies as a filter:
Block all Telnet attempts that originate from the remote host 199.211.211.17.
This rule applies to Telnet packets that come from a host with the IP address 199.211.211.17. If a match
occurs, the packet is blocked.
Here is what this rule looks like when implemented as a filter on the Netopia R7200:
To understand this par ticular filter, look at the par ts of a filter.
Parts of a filter
A filter consists of criteria based on packet attributes. A typical filter can match a packet on any one of the
following attributes:
■ The source IP address (where the packet was sent from)
■ The destination IP address (where the packet is going)
■ The type of higher-layer Internet protocol the packet is carr ying, such as TCP or UDP
Port numbers
A filter can also match a packet’s por t number attributes, but only if the filter’s protocol type is set to TCP or
UDP, since only those protocols use por t numbers. The filter can be configured to match the following:
■ The source por t number (the por t on the sending host that originated the packet)
■ The destination por t number (the por t on the receiving host that the packet is destined for)
By matching on a por t number, a filter can be applied to selected TCP or UDP ser vices, such as Telnet, FTP, and
World Wide Web. The following tables show a few common ser vices and their associated por t numbers:
Internet service TCP port Internet service TCP port
FTP 20/21 Finger 79
Telnet 23 World Wide Web 80
SMTP (mail) 25 News 144
Gopher 70 rlogin 513
+-#--Source IP Addr--Dest IP Addr-----Proto-Src.Port-D.Port--On?-Fwd-+
+--------------------------------------------------------------------+
| 1 199.211.211.17 0.0.0.0 TCP 23 Yes No |
+--------------------------------------------------------------------+