Netopia R7200 User Manual
Page 87
IP Setup and Network Address Translation 10-5
5.
If your ISP uses numbered (inter face-based) routing, select Local WAN IP Address and enter the local WAN
address your ISP gave you. Then select Local WAN IP Mask and enter the WAN subnet mask of the remote
site you will connect to.
The default address is 0.0.0.0, which allows for dynamic addressing, meaning that your ISP assigns an
address via DHCP each time you connect. However, if you want to use static addressing, enter a specific
address.
Note: The Local WAN IP Address is displayed for numbered and/or NAT profiles. The Local WAN IP Mask is
displayed for numbered profiles. The Remote IP Address and Remote IP Mask are displayed for
unnumbered profiles.
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Numbered
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Filter Set...
Remove Filter Set
Receive RIP: Off
Enter an IP address in decimal and dot form (xxx.xxx.xxx.xxx).
Configure IP requirements for a remote network connection here.
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Unnumbered
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
Filter Set...
Remove Filter Set
Receive RIP: Off
Transmit RIP: Off
Return/Enter to select <among/between> ...
Configure IP requirements for a remote network connection here.