NordicTrack NTTL24080 - Manual (Page 6)

6
1. With the help of a second person, carefully raise the
Uprights (92) until the Wheels (119) are resting flat on the
floor.
Assembly
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials yet. A phillips screwdriver (not included) is needed for assembly.
Note: The underside of the treadmill walking belt is coated with a special high-performance lubricant. During ship-
ping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a
normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1
92
119
2. Remove the Lock Knob (105) from the Lock Pin (100).
Make sure that the Lock Pin Collar (102) and the Spring
(103) are on the Lock Pin. Insert the Lock Pin into the
Latch Bracket (104)
Tighten the Lock Knob (105) onto the Lock Pin (100).
Press a Bottle Holder Insert (115) into each side of the
Console Base (116).
2
102
105
104
103
115
100
116
4. Make sure that all parts of the treadmill are properly
tightened. Place a mat beneath the treadmill to protect
the floor or carpet. Note: Keep the included allen wrench
in a secure location. The allen wrench will be needed to
adjust the walking belt (see page 25).
3. Insert the two Book Holder Caps (112) into the Book
Holder (110) as shown. Attach the Book Holder to the
Console Base (116) with the two Book Holder Screws
(111). Be careful not to overtighten the Screws.
Note: Do not hold or push on the Book Holder (110) or
the Book Holder may be damaged.
3
112
112
111
111
116
110