Recoverable post errors, Error and beep codes – NCR 7458 User Manual

Page 20

Advertising
background image

2-2

Chapter 2: POST Diagnostics

Recoverable POST Errors

Whenever a recoverable error occurs during POST, the BIOS displays
an error message describing the problem. If the Beep Error Codes option
is set to ON in BIOS Setup, a series of 2 beeps is issued followed
four (4) groups of 1 to 4 tones. These tones correspond to a specific
Recoverable POST Error. The table below indicates this correlation.
These Beep Codes are to assist in understanding an error in the case
where the primary display is non-functional or a non-LCD/CRT.

Error and Beep Codes

The following is a list of the checkpoint codes written at the start of
each test and the beep codes issued for terminal errors. Not all Test
Points are issued by all of the systems. If no beeps are issued for that
code, the Beeps column remains blank. In such cases, rely on the on-
screen information.

Beeps

Error Message

Corrective Action

Disk Errors

1-1-1-1 0200: Failure Fixed Disk Check

cable/Replace

hard disk

Keyboard Errors

1-2-1-1 0210: Stuck Key

Replace Keyboard

1-2-1-2 0211: Keyboard error

Replace Keyboard

1-2-1-3 0212: Keyboard Controller

Failed

Replace Keyboard

1-2-1-4 0213: Keyboard locked –

Unlock key switch

Replace
Keyboard/Unlock
keyboard

Advertising