NCR 7458 - Manual (Page 46)

3-22 Chapter 3: Hardware Service
Replacing the Compact Flash
1. Hook the bottom of the Compact Flash Bracket onto the slot on the
Hard Disk Bracket (or UPS Bracket or the Chassis as applicable).
2. Snap the standoff into the hole on the bracket.
3. Connect the Compact Flash Power Cable and Compact Flash
Interface Cable.
20331
Slot
Standoff
Note: IDE interface cable connectors are color coded:
• Blue connector – Motherboard
• Black connector – Master Drive
• Gray Connector – Slave Drive/Device (CD-ROM, Compact
Flash when the Secondary Hard Drive is present)
20546
Master Drive
(Black)
Slave Drive
(Gray)
Motherboard
(Blue)