NCR 7458 - Manual (Page 42)

3-18 Chapter 3: Hardware Service
3. Install the Flexible Disk Drive/CD-ROM Assembly in the terminal.
There are two hooks on the bottom of the assembly that should
align with hooks on the Hard Disk Bracket. Slide the Flexible Disk
Drive/CD-ROM Assembly toward the front of the terminal until it
latches into position.
20337
Ribbon Cable Connector
Fan Cable Connector
Latch
Flex Disk Power
Flex Disk
Hard Disk IDE
CD-ROM Power
(From Power
Y-Cable)
4. Reconnect the cables to the disk assembly and Front Panel Control
Board.
Note: IDE interface cable connectors are color coded:
• Blue connector – Motherboard
• Black connector – Master Drive
• Gray Connector – Slave Drive/Device (CD-ROM, Compact
Flash when the Secondary Hard Drive is present)