North Star M165938N - Manual (Page 26)

Operation (cont’d)
26
2. Preparing for Operation
Position generator Position generator in accordance with the instructions given in
“Installation & Initial Set-up, Step 5: Select a Suitable Site” of this
manual.
Operate outside only, on dry, level ground with adequate clearance and
ventilation.
WARNING: Carbon monoxide poisoning hazard
Generators give off carbon monoxide exhaust, a poisonous gas that
can kill. You CANNOT smell it, see it, or taste it. ONLY run
generator OUTDOORS and away from air intakes. NEVER run
generator inside any enclosed or semi-enclosed spaces, including
homes, garages, basements, sheds, boxes, pick-up truck beds, RVs,
or boats. These spaces can trap poisonous gases, EVEN if you run a
fan or open windows. Carbon monoxide exhaust is given off whether
you are using gasoline, natural gas, or propane to power the
generator.
Ground generator Make sure the generator is grounded in accordance with instruction
given in “Installation & Initial Set-up, Step 6: Grounding the
Generator” of this manual.
WARNING: Electric shock hazard
Always ensure generator is properly grounded to prevent electrical shock.
Perform scheduled
maintenance as
needed Make sure that any regular maintenance has been performed as
prescribed in this manual in the “Maintenance & Repair”
section.
1. Refer to the engine owner’s manual for engine maintenance
instructions.
2. Make sure battery is charged. Charge as needed according to your
battery manufacturer’s instructions.
Check/add oil Check the oil level using the dipstick and add oil as needed.
Using a funnel, add oil up to the FULL mark on the dip stick with the
recommended oil type for your engine and expected ambient conditions.
(See engine Owner’s Manual for oil type and capacity, and more detailed oil
check/fill instructions.)
WARNING: Burn hazard
Never open oil port while engine is running. Hot oil can spray over
face and body.
Notes:
o
Low oil shutdown feature prevents the generator from starting without
sufficient oil.
o Engine is shipped without oil. You must add oil before first use.
IMPORTANT:
Under long, continuous-run operating conditions, be prepared to:
• Check engine oil level every time you refuel the engine if using
gasoline, or every 24 operating hours if using NG/LPG.
• Change oil after the first 20 operating hours, and at least every 100
operating hours thereafter, or as directed in engine owner’s manual.