NordicTrack ViewPoint NTL13007.0 User Manual
Page 30
30
Raise the Uprights (85) to the vertical position.
Remove the three #8 x 3/4" Screws (7) from the Hood
(33), and carefully pivot the Hood off.
Locate the Reed Switch (22) and the Magnet (18) on
the left side of the Pulley (17). Turn the Pulley until the
Magnet is aligned with the Reed Switch.
Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8 in. (3 mm). If necessary, move
the Reed Switch slightly using a slotted screwdriver.
Reattach the Motor Hood (not shown), making sure
that the #8 x 3/4" Screws (not shown) are inserted into
the same holes from which they were removed.
Reattach the Hood (not shown). Tip down the
Uprights (not shown), reattach the Belly Pan Screws
(not shown), and raise the Uprights. Run the treadmill for a few minutes to check for a correct
speed reading.
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 14.
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and
UNPLUG THE
POWER CORD. Using the hex key, turn both rear
roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 3 to 4 in. (8 to 10
cm) off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power cord,
insert the key, and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
c. If the walking belt still slows when walked on, please see the front cover of this manual.
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, remove the key and
UNPLUG THE POWER CORD. If the walking belt
has shifted to the left, use the hex key to turn the
left rear roller bolt clockwise 1/2 of a turn;
if the walk-
ing belt has shifted to the right, turn the left rear
roller bolt counterclockwise 1/2 of a turn. Be careful
not to overtighten the walking belt. Plug in the power
cord, insert the key, and run the treadmill for a few
minutes. Repeat until the walking belt is centered.
3–4 in.
b
a
18
22
Top
View
1/8 in.
17
Rear Roller Bolts
33
85
7