Danger – NordicTrack ViewPoint NTL13007.0 User Manual

Page 4

Advertising
background image

4

20. Never leave the treadmill unattended while it

is running. Always remove the key, unplug
the power cord, and switch the reset/off cir-
cuit breaker to the off position when the
treadmill is not in use. (See the drawing on
page 6 for the location of the circuit breaker.)

21. Do not attempt to raise, lower, or move the

treadmill until it is properly assembled. (See
ASSEMBLY on page 7, and HOW TO FOLD
AND MOVE THE TREADMILL on page 27.)
You must be able to safely lift 45 lbs. (20 kg)
to raise, lower, or move the treadmill.

22. When folding or moving the treadmill, make

sure that the frame is held securely in the
storage position.

23. Never insert any object into any opening on

the treadmill.

24. Inspect and properly tighten all parts of the

treadmill regularly.

25.

DANGER:

Always unplug the power

cord immediately after use, before cleaning the
treadmill, and before performing the mainte-
nance and adjustment procedures described in

this manual. Never remove the motor hood un-
less instructed to do so by an authorized ser-
vice representative. Servicing other than the
procedures in this manual should be performed
by an authorized service representative only.

26. This treadmill is intended for in-home use

only. Do not use this treadmill in a commer-
cial, rental, or institutional setting.

27. To reduce the risk of electric shock, do not re-

move the cover or the back of the television.
There are no user serviceable parts inside.
Refer servicing to qualified service personnel.

28. Upon completion of any service or repairs to

the treadmill or the television, ask the service
technician to perform safety checks to con-
firm that the unit is in proper operating con-
dition.

Note to CATV system installer: This reminder
is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.

Advertising