Napoleon Fireplaces GDS60N - Manual (Page 34)

34
W415-0788 / A / 09.22.09
6.0 FINISHING
6.2 GLASS DOOR INSTALLATION AND REMOVAL
6.2.1 Lift the top casting off.
6.2.2 Lift the cast front out of its retainers (located at either side on the top).
6.2.3 Open the valve control cover. Pull the latch handles forward to release. The door may now be safely
removed by swinging the bottom out and lifting it off. To install the door, repeat in reverse order.
The return fl ange must fi t over the top of the ridge so that it rests on top of the fi rebox.
The 'T' latch portion is threaded and can be loosened or tightened to adjust for an effective door seal.
Care must be taken when re-installing the door to ensure that the gasket at the top of the door does
not bunch.
When installing the glass door, a simple procedure must be followed in order to not damage the door.
LATCH
RIDGE
RETURN
FLANGE
6.1 FRONT CAST REMOVAL
6.1.1 Lift the top casting off the unit.
6.1.2 Loosen the securing bolts on the cast front (located at either side on the top). Lift up and out.
6.1.3 To install the front, repeat in reverse order.
FIGURE 6.2.3a-b