Napoleon Fireplaces GDS60N - Manual (Page 39)

39
W415-0788 / A / 09.22.09
8.0 WIRING DIAGRAM
ON / OFF
SWITCH
ACS/IPI
SWITCH
DC BACK-UP
GROUND
DFC
VALVE
ORANGE
GREEN
GROUND
EYELET
ON / OFF
IPI / CPI
DISCONNECT THESE
CONNECTORS TO THE
ON/OFF SWITCH AND
CONNECT TO
OPTIONAL WALL /
THERMOSTAT SWITCH
AND / OR SPILL SWITCH
TO “B” VENT ADAPTOR
+
+
-
-
IPI BOARD
DC SUPPLY
TRANSFORMER
VALVE
ELECTRONIC
This appliance comes equipped with a battery back-up. If this backup is used install four AA batteries (not
supplied) into the holder and connect to the wire harness. Place near the IPI board. Connect the battery holder
to the wire harness before using the appliance. Place near the IPI board. (Batteries not included). If backup is
used, it must be connected to the 6 volt battery pack supplied.
FIGURE 8.0