Nikon NP4100 - Manual (Page 110)

5. Using On-Screen Display
95
I
TEM
D
ESCRIPTION
Color System
Select the default Color System to use for Video or S-Video input.
Range: Auto, NTSC3.58, NTSC4.43, PAL, PAL-M,
PAL-N, PAL60, SECAM (see page
99 ).
WXGA Mode Select WXGA mode (see page 99 ).
Source
Display
Select the message display such as Computer 1, Computer 2, Computer 3,
Component, Video, and No Input to be displayed on the top right of the
screen.
Range: On or Off (see page
99 ).
Control ID
Set the Remote Control ID code.
Range: 1~254 (see page
100 ).
Filter Message
Set this item to on to have the projector display a message when the air
filter needs servicing.
Range: Off, 100[H], 200[H], 500[H], 1000[H] (see page
100 ).
Auto Power On (AC)
Auto Power On (AC) enables the projector to start automatically when the power cable is
connected to an active power outlet and the main power switch is on. This eliminates the
need to always use the POWER (ON/STANDBY) button on the remote control or projec-
tor cabinet. To use the Auto Power On (AC) function, you must first press the main
power switch to On before connecting the power cable.
Note:
y When the projector is off by using the POWER button (or put in the standby
mode) and the power cable is disconnected, Auto Power On (AC) will not activate
after power (AC) is applied.
y When the projector is off by using the Direct Power Off function or after the
power (AC) is removed (no standby mode), Auto Power On (AC) will be activated
after power (AC) is applied.
y The Direct Power Off function means you can turn off the power (AC) to the
projector by using a power strip equipped with a switch and a breaker.