Nikon NP4100 - Manual (Page 55)

3. Projecting an Image (Basic Operation)
40
Selecting a Source
The Source can be selected from the projector's control panel or from the remote control unit.
Refer to the following guide to select Source.
1.
Press Menu on the OSD
control panel or on the
remote control unit to dis-
play the Main Menu.
Scroll to the Source menu
using ▲or▼ and press
Enter.
Note:
Return to the projected
image by pressing Exit
twice.
2.
Select the required source
using ▲or▼ and press
Enter.
Note:
If an XGA signal is not correctly recognized on NP4100W, set "WXGA Mode" to
Off (see page
99 ).
To check if the signal is recognized, go to "Source" under "Information" menu (see
page
3
102 ).