Chapter 3 signal connections, Signal connections – National Instruments BNC -2140 User Manual
Page 12
Advertising
© National Instruments Corporation
3-1
3
Signal Connections
This chapter describes how to connect input and output signals to your
BNC-2140.
You can connect the external analog signals through six BNC connectors.
Four of the BNC connectors are for input signals and two of them are for
output signals.
The SHC68-C68-A1 shielded cable connects the BNC-2140 internal
analog signal connector to the DSA plug-in device. A single 68-pin 0.8 mm
VHDCI connector connects the analog I/O signals to the shielded cable.
Advertising