New Transducers TR-5001 - Manual (Page 15)

Set the check box (Use Multiple Monitors) to enable multiple monitors mapping. Unchecking
this box will disable multiple-monitor configuration, and all of the touch panel controllers will
be mapped to the primary monitor. The gray shadow area is the monitor mapped to the selected
controller/panel. The button [Mapping] is used to find the mapping relationships between the
monitors and touch panel controllers. Press [Mapping] and the software will guide you to
touch the corresponding monitor to obtain the mapping relationship.
After completing monitor mapping, Press [Apply] to apply the mapping relationship.
Split Monitors
To use the Split Monitor function, you need to select which controller you want to launch this
function, then check the Multiple Monitors box and Split Monitor at the same time as shown
below. Press the [Split Monitor] button to set up the active area.
It shows the current resolution of the display and you can set the active area by inputting the
value or use the default button [Upper Half], [Left Half] or [Quarter]. The default value of
panel resolution should be full screen as Left: 0, Right: 0, Top: 0 and Bottom: 0.
5. ABOUT: General information about TouchKit.
Uninstalling TouchKit
To uninstall, use the TouchKit/Uninstall from the Programs menu on the Start button.
11 TR-5001 User Manual