User parameter switch summary – Ricoh BIZWORKS 106 User Manual
Page 411
103
TECHNICAL REFERENCE
8. TECHNICAL
REFERENCE
Registered
5 Select
O
K
02 :1110 1000
O
K
6
To toggle the value of a single bit, press
the number on the numeric keypad that
corresponds to the number of the bit
you wish to change.
E.g. press
to change bit 3.
7
Press
. The display opposite will
flash briefly on the display and then the
function menu will reappear.
Note
Do not carry out any operations while “Reg-
istered” appears on the display.
8
Do one of the following:
• Enter another function number.
• Press Help/Function to return to standby mode.
SWITCH 00 (
1
/
2
)
Explanation
Width scanned when faxing
a document
Display “Original left on
glass.” Warning when scan-
ning from the ADF and an
original is left on the expo-
sure glass
Maximum length of docu-
ment when scanning from
the ADF
Automatically print the
Transmission Result Report
after every successful trans-
mission
Default
210mm (A4)
Yes
400mm
No
Bit
7
6
5
4
Available
Settings
0: 210 mm (A4)
1: 216mm (LT/LG)
0: Yes
1: No
0: 400mm
1: 1200mm
0: No
1: Yes
Notes
This setting takes effect
from the next power on.
This setting takes effect
from the next power on.
Please wait
User Parameter Switch Summary
The following tables summarize the User Parameter bit switches and their
meanings.
b(GB)6.5_Chapter 08_p101-108
99.8.3, 1:18 PM
103