Radio Shack 64 - Manual (Page 15)

15
If the VCR does not detect an EDS signal
within this time,
AUTO CLOCK SET
INCOMPLETE appears. There is proba-
bly not an EDS signal available in your
area. Press
MENU/ACTION , then see “Man-
ually Setting the Clock” to set the clock.
Notes:
• Your VCR protects tuner programming
for up to 24 hours in case a power failure
occurs or if the power cord becomes
unplugged. After about 24 hours without
power, the VCR loses the programming.
• If you have not connected the VCR to an
antenna, cable TV, direct-to-home satel-
lite receiver, or other signal source
through the
IN FROM ANT. jack, the VCR
does not store any channel in memory.
Instead, you see:
Manually Setting the Clock
Follow these steps to manually set the clock if
EDS is not available in your area, if you do not
want the VCR to search for an EDS signal, or if
you skipped tuner programming.
Notes:
• The clock must be accurately set for proper
automatic timer recording. We suggest you
refer to a radio station or time/temperature
service for the correct time.
• If you do not press a button within 5 min-
utes in Steps 2–9, the clock is not set. Start
again from Step 1
1. Press MENU/ACTION to display the main
menu.
Note: To exit the programming mode at
any time, press
MENU/ACTION again.
2. Repeatedly press (marked above PLAY
on the remote control) or (marked
below STOP on the remote control) to high-
light SET CLOCK , then press (marked
to the right of FAST-F on the remote con-
trol).
3. Repeatedly press or to highlight
MANUAL , then press .
4. Repeatedly press or to select the
correct month, then press .
5. Repeat Step 4 to select the correct date,
year, and hour, then press .
6. Repeatedly press or to select a
minute that is 1 or 2 minutes after the cur-
rent time, then press
. (For example, if it
is 42 minutes past the hour right now, enter
43 minutes now.) This gives you time to
complete this procedure before starting the
clock.Note: Your VCR uses a 12-hour
clock. Be sure you correctly set AM or PM.
7. Repeatedly press or to set DST
(daylight saving time) to ON or OFF .
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
NO CH FOUND
RE
NEL
UE : ENGL I SH
Y
KEY
- - - - - - - - -
CK SET
Y
KEY
CK
- - - - - -
DST : ON
:
Y
KEY
- -- - - - - -
K
- - - - - -
16-634.fm Page 15 Tuesday, July 20, 1999 5:37 PM