Radio Shack 64 - Manual (Page 35)

35
Notes:
• To ensure that you record the entire pro-
gram, set the recording length longer
than the program length.
• To display the remaining recording time,
press DISP/ENT during a timed recording.
• To temporarily stop the tape during a
recording, press PAUSE . Press PAUSE
again to resume recording. If you leave
the VCR paused for about 5 minutes,
the VCR automatically stops.
• If the cassette’s erase protection tab has
been removed, the VCR ejects the cas-
sette and
CHECK CASSETTE RECORD
TAB appears. Use another cassette, or
place a piece of heavy plastic tape over
the erase-protection tab hole.
10. Press STOP to stop recording at any time
before it automatically stops.
Recording One Program on the VCR
While You Watch Another on the TV
1. Follow Steps 1 – 9 of “Recording a Program
as You Watch It” on Page 34.
2. Repeatedly press TV/VCR until VCR disap-
pears.
Note: If you are watching the program on a
TV/monitor that is connected to the VCR’s
R-AUDIO-L/VIDEO OUT jacks, set the TV/
monitor to its TV mode.
3. Set the TV tuner to the channel you want to
watch.
4. Press STOP to stop recording at any time
before it automatically stops.
AUTOMATIC TIMER
RECORDING
The VCR’s automatic timer lets you program it
to select an input source, start recording from
that source at a time you set, then stop record-
ing at a time you set. You can set up to eight
timers to record any combination of daily,
weekly, or one-time events.
You can set the VCR to record at any time on a
specific day within a 1-month period, at the
same time Monday through Friday (DAILY), or
at the same time on the same day every week
(WEEKLY).
Notes:
• The VCR can record only one broadcast at
a time. If you set the VCR’s timer to record
broadcasts on different channels that start
at the same time, the VCR only records the
broadcast that has the lowest timer num-
ber (see “Checking/Changing Timers” on
Page 37).
• If two timer settings overlap, the one that
starts first has priority. The VCR begins
recording the second broadcast after the
set time for the first broadcast is over.
• The VCR must be off at the start time you
set for it to begin an automatic timer
recording.
• If there is a power failure of more than 1
minute during a timer recording, the
recording does not resume after power is
restored.
• If there is a power failure of more than 1
minute before a start time, the VCR loses
the clock setting and therefore does not
start automatic timer recording. However, if
you have an EDS channel in your area and
set the VCR to automatically set the clock
from the EDS signal, the clock is reset
within 10 minutes after power is restored,
and the VCR records at the set time(s).
16-634.fm Page 35 Tuesday, July 20, 1999 5:37 PM