Radio Shack 64 - Manual (Page 20)

20
2. While holding down TV , enter the code
number for your TV using the number but-
tons Or, while holding down
DSS/CABLE ,
enter the code number for your cable box
or direct-to-home satellite receiver.
Precede a single-digit code number with a
0 — for example, 01, 02, and so on. To
enter a three-digit number, press
100 , then
enter the second and third digits in the
code number.
3. Try operating your TV and cable box or
direct-to-home satellite receiver using the
VCR’s remote control. First press
TV or
DSS/CABLE , then try pressing POWER ,
INPUT , CH s or CH t, and VOL +/– for TV
operation; or POWER and CH s or CH t for
cable box or direct-to-home satellite
receiver operation.
If the device does not function, repeat Step
2 and try other codes for the manufacturer.
If it still does not function, you must use the
original remote control supplied with your
TV and cable box or direct-to-home satel-
lite receiver.
To use the remote control, press the button for
the device you want to control—
TV , DSS/CABLE ,
or VCR . Then press the desired function button.
Notes:
• The codes you programmed might be
erased if you remove the batteries from the
remote control (to replace them, for exam-
ple). If this happens, re-enter the codes
after you replace the batteries.
• Some TVs, cable boxes, and direct-to-
home satellite receivers might require that
you manually turn on the power for that
device.
• Your TV, cable box, or direct-to-home sat-
ellite receiver might have functions that the
VCR’s remote control will not operate.
• You can use the number buttons to select a
channel number on your TV and cable box
or direct-to-home satellite receiver. How-
ever, some TVs and cable boxes or direct-
to-home satellite receivers might require
that you press
DISP/ENT after entering the
channel number.
• VOL +/– works to adjust the TV volume in
any operation mode (VCR, TV, or DSS/
CABLE).
• When you press TV or DSS/CABLE then
press MENU/ACTION or PROG , NOW TV/
CABLE/DSS MODE PLEASE PUSH VCR
KEY ON REMOTE appears, and TV or
CAbL flash for about 5 seconds then dis-
appear. Press VCR to set the remote con-
trol to VCR operation mode.
16-634.fm Page 20 Tuesday, July 20, 1999 5:37 PM