Stopping playback of the pattern being played, Disabling the pad pattern function, Enabling cross sticks – Roland TD-12 User Manual
Page 29: Playing along with patterns, Choosing a pattern, Muting a specific part, Choosing a pattern muting a specific part
29
Useful Functions to Know
Overview
3.
Use [+/-] or [VALUE] to select “PRESET” for the
copy-source type.
4.
Use [CURSOR], [+/-], or [VALUE] to select the
copy-source kit and the copy-destination kit.
5.
Press [F5 (COPY)].
The confirmation screen appears.
* To cancel, press [F1 (CANCEL)].
6.
Press [F5 (EXECUTE)] to carry out.
You can set up a pattern beforehand and then strike a pad to
start the performance of the pattern (press [INST] - [F4
(CONTROL)] - [F1 (PATTERN)]; p. 37).
Some factory set drum kits (Preset drum kits) have this
function set.
* When playing back patterns with recorded drum kit
performances or demo songs, the patterns assigned to the pads
are not played back, even if the Pad Pattern function is enabled
for the selected drum kit.
* Performances using the Pad Pattern function cannot be
recorded to sequencers.
* With Pad Pattern, performance of the pattern starts only when
the pad is struck with sufficient force.
If the pad is struck weakly, only the instrument sound assigned
to the pad is played; the pattern is not played back.
Press [STOP].
You can switch off the Pad Pattern function for the entire kit,
without having to individually change the settings for each
pad.
Set PadPtn Master Sw (press [KIT] - [F2 (FUNC)] - [F4 (PAD
PTN)]; p. 32) to “ALL PADS OFF.”
You can switch drum kits and patterns by striking the pads
connected to AUX 1 and AUX 2 (press [SETUP] - [F3
(CONTROL)] - [F1 (PAD SW)]; p. 76).
1.
Press [KIT].
2.
Press [F5 (XSTICK)].
The cross-stick sound is alternately switched on and off
each time you press this.
* Select an instrument from the Drum Instrument List (p. 88)
with “*X” appended to the name.
1.
Press [PATTERN].
[PATTERN] lights, and the “PATTERN” screen appears.
2.
Use [+/-] or [VALUE] to select the pattern.
3.
Press [PLAY].
[PLAY] lights, and playback of the pattern begins.
1.
Press [PATTERN] - [F2 (PART)] - [F5 (MUTE)].
The “PART MUTE” screen appears.
2.
Press [F1]–[F5] to turn each part muted or
played.
Playing Back Patterns by
Striking the Pads
(Pad Pattern Function)
Stopping Playback of the Pattern
Being Played
Disabling the Pad Pattern Function
Striking a Pad to Switch the
Drum Kits
(Pad Switch Function)
Enabling Cross Sticks
Playing Along with Patterns
Choosing a Pattern
Muting a Specific Part
TD-12_e.book 29 ページ ２００５年２月１８日 金曜日 午後６時３９分