Rosewill RC200 User Manual
Page 12
ULTRA ATA/133 PCI RAID Card
RC200 User Manual
12
15.
Answer Y to enable Auto-rebuild.
16.
When asked Are You Sure?, Press Y to accept.
17.
Press ESC to exit the RAID BIOS and reboot the computer.
RAID 0+1 (Mirror+Striping)
This RAID array to be used on New/Blank hard drives only, striping destroys existing data
on the hard drive. RAID 0+1 requires at least four hard drives.
For Manual Setup
1.
As the BIOS boots press F3 when prompted to enter the RAID BIOS.
2.
At the next screen press F2 to from a RAID set.
3.
Press F3 to create RAID 0+1.
4.
Choose the chunk size by pressing the appropriate number key(64 is recommended).
5.
Enter the first Source drive, then enter the second source drive.
6.
Note: To optimize performance, configure both source drives to be from different
channels and configure both destination drives to be from different channels.
7.
Enter the first destination drive, then enter the second destination drive.
8.
Enter Y to accept the RAID configuration.
9.
On the following screen press ESC to exit the RAID configuration utility and reboot the
computer.
10.
Continue with FDISK and FORMAT steps as if you were installing a conventional hard
drive.