Rosewill RC200 User Manual
Page 22
ULTRA ATA/133 PCI RAID Card
RC200 User Manual
22
7.
D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive
you are using. If D is not letter of your CD-ROM drive, substitute D with the correct
drive letter), then click Next.
8.
Click Next again, then Finish.
9.
Restart Windows to complete driver installation.
＊
For Existing Windows® 98SE Installation
1.
Setup the RAID Array prior to driver installation.
2.
Install the board and boot up Windows® 98SE.
3.
At the Add New Hardware Wizard, click Next.
4.
Select Search for the best driver for your device and click Next.
5.
Insert the driver CD into the CD-ROM Drive and click Next.
6.
Select Search for the best driver for your device(Recommended) from the following
dialog box and type
7.
D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive
you are using. If D is not letter of your CD-ROM drive, substitute D with the correct
drive letter), then click Next.
8.
Click Next again, then Finish.
9.
Restart Windows to complete driver installation.
For Windows® ME
＊
For New Windows® ME Installation
1.
Setup the RAID Array prior to Windows installation.
2.
Install the board and follow Microsoft procedures to install Windows® ME accordingly.