Raid 1 (mirror – Rosewill RC200 User Manual
Page 9
ULTRA ATA/133 PCI RAID Card
RC200 User Manual
9
RAID 1 (Mirror
)
For Manual Setup
＊
For New/Blank Hard Drives
Recommended for all fresh HD without data.
1.
As the BIOS boots press F3 when prompted to enter the RAID BIOS.
2.
At the next screen press F2 to from a RAID set.
3.
Press F2 to create RAID 1. In a Mirror set the source drive needs to be equal to or
smaller than the destination drive. For optimal performance the source drive and
destination drive should be on separate IDE channels.
4.
Answer N to Auto Setup.
5.
Assign Source drive, then assign Destination drive.
6.
Assign N when asked to Copy from Source to Destination.
7.
Answer Y to Enable Auto-Rebuild.
8.
When asked Are you Sure? Press Y to accept.
9.
Press ESC to exit the RAID BIOS and boot the computer.
＊
For Existing Hard Drives with Data
Recommended for one/two original HD with data to mirror with one/two fresh
empty HD
1.
As the BIOS boots press F3 when prompted to enter the RAID BIOS.
2.
Press F2 to enter the RAID setup screen.
3.
Press F2 to from RAID set 1.
4.
Answer N to Automatic setup.