Rosewill RC200 User Manual
Page 23
ULTRA ATA/133 PCI RAID Card
RC200 User Manual
23
3.
Once Windows has been installed, right click My Computer and click Properties. Select
Device Manager tab.
4.
Double click PCI RAID Controller listed under Other Devices.
5.
Select Driver tab, then click Update Driver button.
6.
Insert the driver CD into the CD-ROM Drive and click Next.
7.
Select Search for the best driver for your device(Recommended) from the following
dialog box and type
8.
D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive
you are using. If D is not letter of your CD-ROM drive, substitute D with the correct drive
letter), then click Next.
9.
Click Next again, then Finish.
10.
Restart Windows to complete driver installation.
＊
For Existing Windows® ME Installation
1.
Setup the RAID Array prior to driver installation.
2.
Install the board and boot up Windows® ME.
3.
At the Add New Hardware Wizard, click Next.
4.
Select Search for the best driver for your device and click Next.
5.
Insert the driver CD into the CD-ROM Drive and click Next.
6.
Select Search for the best driver for your device(Recommended) from the following
dialog box and type
7.
D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive
you are using. If D is not letter of your CD-ROM drive, substitute D with the correct drive
letter), then click Next.