Regency L234-NG - Manual (Page 22)

Regency ® L234 Direct Vent Gas Insert 22
INST
ALLA
TION
OPTIONAL HEARTH TRIM
1) Open the left and right side faceplate panels.
2) Align the screw holes on the hearth trim with the screw holes on the
fl anges on the left and right side faceplate. Secure in place using 2
screws on each side as shown in diagram 1.
3) Close the left and right side faceplate panels.
Completed Hearth Trim Installation:
Faceplate shown without left
and right side panels to show
mounting of hearth trim.
a) The Hearth Trim can be adjusted to custom fi t an installation by
pulling apart the top piece from the bottom piece.
b) Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure the
height required.
c) Reattach the top piece of the hearth trim to the cut bottom piece by
fi tting in place.
Hearth Trim Contents List:
4 Screws (10-24 x 1/2" Truss Head)
1 Hearth Trim
Customize Hearth Trim:
Hearth Trim Installation:
Diagram 1
INSTALLATION