Ricoh DDST A - Manual (Page 11)

Connecting the Machine
5
1
Connecting the Machine
Reference
For details about connection using
Ethernet, see "Connecting the Net-
work Cable to the Network", Net-
work Guide.
Requirements
Before using this machine, make sure
all environmental and electrical re-
quirements are met. Connect the ma-
chine to the host computer using the
USB port or network interface unit.
Make sure all cables, connectors, and
electrical outlets necessary to attach
the machine to the host computer or
network are close at hand.
Connecting the machine to the
host using a USB cable
You can connect the machine to the host
computer using a USB interface cable.
The USB cable is provided according
to machine model:
• Standard model
The USB cable is provided for this
model.
• Network standard model
The USB cable is not provided for
this model. Purchase a cable that is
suitable for connecting this model
to your computer.
Follow the procedure below to con-
nect the machine to the host computer
using a USB interface cable.
A
Connect the USB 2.0 interface ca-
ble to the USB port on the right
side of the machine's back cover.
B
Connect the other end to the USB
port on the host computer.
The machine and computer are
now connected. The printer driver
and TWAIN driver must be in-
stalled next. For details about how
to install the printer driver and
TWAIN driver, see p.8 “Installing
the Printer Driver” and p.9 “In-
stalling the TWAIN Driver”.
Note
❒ If USB 2.0 is used with Win-
dows 98 SE/Me, only a speed
equivalent that of USB 1.1 is
possible.
ANX001S