Ricoh DDST A - Manual (Page 22)

Using the Printer Function
16
3
System
❖ Auto Continue
You can select this to enable Auto
Continue. When it is On, printing
continues even after a system error
occurs.
• Off
• 0 minutes
• 1 minute
• 5 minutes
• 10 minutes
• 15 minutes
Note
❒ Default: Off
❖ Edge Smoothing
Set this to enable Edge Smoothing.
• On
• Off
Note
❒ Default: On
❒ If Toner Saving is set to On,
Edge Smoothing is ignored
even if it is set to On.
❖ Toner Saving
Set this to enable Toner Saving.
• On
• Off
Note
❒ Default: Off
Host Interface
❖ I/O Timeout
You can set how many seconds the
machine should wait before end-
ing a print job. If data from another
port usually arrives in the middle
of a print job, you should increase
this timeout period.
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
Note
❒ Default: 15 seconds