Radio Shack pmn - Manual (Page 10)

10
Installation
Notes:
² When you first use the phone after charging or recharging the
battery pack, the phone might not work and you might hear a two-
beep signal when you press
PHONE . If this happens, return the
handset to the base for about 30 seconds. This resets the security
access protection code.
² If the CHARGING indicator does not light when you place the
handset on the base, be sure the battery pack and AC adapter are
correctly and securely connected.
Also, check the charging
contacts on the handset and
the base. If the contacts are
dirty or tarnished, clean them
with a pencil eraser.
² If the battery pack gets completely discharged or the base loses
power while the handset is away from it, the security access-
protection code needs to be reset. To reset the code, place the
handset on the base for about 30 seconds. If it was the handset
that lost power, leave the handset on the base to charge the bat-
tery pack.
² If the battery pack gets weak during a call, the handset sounds
4 beeps every 30 seconds. If this happens, you cannot make
another call on the phone until you recharge the battery pack.
² About once a month, fully discharge the battery pack by keep-
ing the handset off the base until the LOW BATT indicator lights.
Otherwise, the battery pack loses its ability to fully recharge.
² If you are not going to use your phone for an extended period of
time, disconnect the battery pack. This increases the battery
pack’s usable life.
Charging
Contacts
43-5514.fm Page 10 Wednesday, August 18, 1999 12:47 PM