Radio Shack pmn - Manual (Page 17)

17
Telephone Operation
To stop the handset from beeping before it automatically stops,
press
CHANNEL on the handset or PAGE/HANDSET LOCATOR on
the base.
Note: You cannot page the handset during a call.
MEMORY DIALING
You can store up to 10 numbers (up to 16 digits each) in memory,
then dial a stored number by pressing
PROG/MEM and one of the
number buttons.
Storing a Number in Memory
Notes:
² If the dialing mode is set for pulse service and you want to use
tone dialing for a memory number, you must store a tone as the
first entry of the number (see “Using Tone Services on a Pulse
Line” on Page 16).
² Do not store a number with both pulse and tone entries in the
same memory location. This could result in a wrong number being
dialed.
² Each pause (see “Entering a Pause” on Page 18) and tone
entry uses one digit of memory.
² To keep your accounts secure, we recommend you do not store
your personal access code for services such as bank-by-phone in
a memory location.
² An error tone sounds and the phone exits the programming
mode if you wait more than 30 seconds between each keypress or
enter more than 16 digits. You must start over at Step 1.
Follow these steps to store a number in memory.
43-5514.fm Page 17 Wednesday, August 18, 1999 12:47 PM