Runco LIGHTSTYLE LS-3 - Manual (Page 67)

Operation
Runco LS-3/LS-5 Installation/Operation Manual 51
PRE
L
IMINAR
Y
Advanced Use the controls in the Advanced menu, shown in Figure 4-8, to perform advanced image
adjustments.
Figure 4-8. LS-3/LS-5 Advanced Menu
Color Space: Select Color Space from the Advanced menu to choose the color space of
the source signal for HDMI, RGB, and component connections.
• The default setting, Auto, functions as follows:
• HDMI: If the Auxiliary Video Information (AVI) infoframe contains color space and/or
range data, the LS-3/LS-5 uses that information. Otherwise, for RGB sources, the
LS-3/LS-5 uses the RGB-Video color space. For component SDTV and EDTV
resolutions, REC601 is used. For other component video resolutions, REC709 is
used.
• RGB: If Hsync or Vsync signals are present, the LS-3/LS-5 uses the RGB-PC color
space. Otherwise, REC601 is used for SDTV and EDTV sources, and REC709 for
all other sources.
• Component: For SDTV and EDTV resolutions, the LS-3/LS-5 uses the REC601
color space. For all other resolutions REC709 is used.
In most cases, the Auto setting determines the correct color space to use. If it does not,
you can force the LS-3/LS-5 to use a specific color space. Choose one of the following:
• REC709 sets the color space matrix to that defined in ITU-R BT.709.
• REC601 sets the color space matrix to that defined in ITU-R BT.601.
• RGB-PC uses RGB color space and sets black at 0,0,0 RGB and white at
255,255,255 RGB, assuming an 8-bit image.
• RGB-Video uses RGB color space and sets black at 16,16,16 RGB and white at
235,235,235, assuming an 8-bit image, to correspond to the luminance values defined
in digital component standards.