Runco LIGHTSTYLE LS-3 - Manual (Page 75)

Operation
Runco LS-3/LS-5 Installation/Operation Manual 59
PRE
L
IMINAR
Y
PIP Position: To change the position of the PIP image, choose PIP Position from the
System menu; see Figure 4-13. Choose one of the following:
• Top Left: This places the PIP source into a 644x362 designated image area at the top
left of the screen.
• Top Right: This places the PIP source into a 644x362 designated image area at the
top right of the screen.
• Bottom Left: This places the PIP source into a 644x362 designated image area at the
bottom left of the screen-safe area of the DMD.
• Bottom Right: This places the PIP source into a 644x362 designated image area at
the bottom right of the screen-safe area of the DMD.
• Picture-By-Picture: This reduces the designated image area of the Active source to
921x518 and places it next to the PIP source, which is also in a 921x518 image area.
These two images are centered on the screen.
• Split Screen: This is a special mode in which the active source is also used as the PIP
source and placed in a PIP area equal to half the display on the left side. This results in
the right half of the image being the active source and the left half is the PIP source.
The LS-3/LS-5 applies the User Memory 2 settings to the PIP image.
Split-screen mode is useful for viewing “before” and “after” settings for Sharpness,
Noise Reduction and other advanced image parameters. See Figure 4-14.
Figure 4-13. PIP and PBP areas for 1080p Display
DMD Area 1920x1080
Screen-Safe Area 1842x1036
921x518 921x518
644x362
PIP
(top right)
PBP2 PBP1