Radio Shack DX-398 - Manual (Page 29)

29
4. While PAGE and MEMO flash,
repeatedly press TUNING or
to select the page where you
want to store the frequency.
The page’s number appears
under
PAGE and the name of the
page’s country appears as you
press
TUNING or . For
each page, the number of the first
available empty memory location
in that page flashes next to
MEMO .
Note: If you wait more than 10
seconds to press
TUNING or
, PAGE and MEMO stop flash-
ing. If this happens, start again at
Step 3.
5. Press ENTER to assign the
frequency to the flashing memory
location. The receiver beeps and
a bracket appears around the
number where you stored the fre-
quency.
Notes:
• If the receiver’s memory is full,
MEMOFULL appears when you
press a number key.
• To replace a frequency you
stored with a new frequency,
repeatedly press
TUNING
or TUNING to select a new
frequency, press M/MEM , then
hold down the number key cor-
responding to that memory
location for about 2 seconds.
The receiver beeps and stores
the new frequency in the mem-
ory location.
ASSIGNING A NAME TO
AN FM/MW/LW STATION
OR SW PAGE
To help you easily identify stored fre-
quencies, you can assign a name (up
to 8 characters) to an FM, MW, or LW
memory location, or to an SW page.
1. Select a band (see “Selecting a
Band” on Page 18).
2. Repeatedly press PAGE to select
the page number where you
stored the desired frequency.
3. For an FM, MW, or LW station,
use the number keys to enter the
desired memory location number.
4. Press EDIT . A cursor flashes
under the displayed frequency for
about 30 seconds.
5. While the cursor flashes, turn
MANUAL TUNING until you see the
first character you want to use.