Radio Shack DX-398 - Manual (Page 30)

30
Note: If you wait more than 20
seconds to turn
MANUAL TUNING ,
the cursor stops flashing. If this
happens, start again at Step 4.
6. When the character you want
appears, press TUNING to
move to the next position, then
rotate
MANUAL TUNING to select
the next character.
Note: If you want to correct a
character you entered, press
TUN-
ING to move back to it.
7. When you have finished entering
the name, press ENTER .
DELETING A STATION
YOU STORED
1. Select a band (see “Selecting a
Band” on Page 18).
2. Press ENTER
.
3. Repeatedly press PAGE until the
page with the desired frequency
appears.
4. Use the number keys to enter the
memory location number.
5. Press M/MEM.
6. Press C (cancel).
LOCKING/UNLOCKING A
STORED STATION
After storing your favorite stations, you
can lock any of them in memory. This
helps you avoid overwriting the station
if you accidentally use the receiver’s
ATS automatic store feature.
To lock or unlock a station, recall the
station, press
M/MEM then press
. appears (locked) or dis-
appears (unlocked).
MOVING A FREQUENCY
TO ANOTHER MEMORY
LOCATION
Note: These steps show you how to
move a frequency to another memory
location on the same page. To move
the frequency to another memory lo-
cation on a different page, follow the
steps in “Storing FM, MW, or LW Fre-
quencies in Memory” on Page 27 or
“Storing SW Frequencies in Memory”
on Page 28.
1. Select a band (see “Selecting a
Band” on Page 18).
2. Recall the memory location num-
ber of the frequency you want to
move.
3. Press M/MEM . MEMO and the
memory location where the sta-
tion is programmed flash.
M