Radio Shack DX-398 - Manual (Page 32)

32
TIMER FUNCTIONS
USING THE TIMER
ALARMS
Your receiver has three timer alarms.
You can set these alarms to sound
(buzzer or radio) at a time you set.
Setting an Alarm
1. If you want the radio to turn on at
the alarm time, tune to the desired
station. Then press
M/MEM . MEMO
and the memory location where
the station is programmed flash
for about 10 seconds.
2. Press TIMER 1 , TIMER 2 , or TIMER
3 twice. , the selected timer
number, and (buzzer) flash for
about 10 seconds.
Note: If MEMO stops flashing
before you press TIMER 1 , TIMER
2 , or TIMER 3 , start again from
Step 2.
3. To select the type of alarm (buzzer
or radio), repeatedly press AM
MODE until for the buzzer or
for the radio flashes next to
.
Note: If or , stops flashing
before you press AM MODE , start
again from Step 2.
4. Use the number keys to enter the
time you want the alarm to sound.
5. Press ENTER .
6. Turn the receiver off.
Silencing the Alarm
When the display shows the alarm
time, the radio turns on or the buzzer
sounds and
, 1 , 2 , or 3 , and
or flash on the display.
If you selected the buzzer, its volume
increases after several seconds. After
a few more seconds, the buzzer’s vol-
ume increases again. Then, after 60
seconds, the buzzer turns itself off
and sounds again the next day at the
set time.
If you selected the radio, it automati-
cally turns off after 60 minutes. To si-
lence the radio or the buzzer sooner,
press
POWER to turn off the receiver.
, 1 , 2 , or 3 , and or dis-
appear and the alarm sounds again
the next day at the set time.
Using the Snooze Feature
To silence the buzzer or radio alarm for
about 5 minutes, press any button ex-
cept
POWER , , or .
flashes above . This temporarily
silences the buzzer or radio and then it
sounds again. You can repeat this for
up to 30 minutes using the buzzer
alarm or up to 60 minutes using the ra-
dio alarm.
Note: The snooze feature does not
work if a plug is connected to the
REC
LINE OUT jack.
TIMER
TIMER
TIMER
TIMER
M Z Z
Z