Ricoh 1013F - Manual (Page 20)

Basics
8
1
Starting the Machine
AAAA
Press the operation switch to make the On indicator go on.
The display panel will come on.
Note
❒ If the power is not turned on when the operation switch is pressed, check
if the main power switch is on. If off, turn it on.
❒ During the warm-up period (less than 20 seconds), you can use the Auto
Start function. See p.31 “Auto Start”.
❒ You can set up a copy job and press the {{{{Start}}}} key while the “Select Modes
and Press Start” message is displayed.
❒ When “Input User Code and Press OK” is displayed, enter your user code.
Shutting Down the Machine
AAAA
Press the operation switch to make the On indicator go off and change to
Low Power mode.
Turning Off the Main Power
AAAA
Turn off the main power switch.
The main power indicator of the control panel goes off.
Important
❒ Fax files stored in memory will be lost 12 hours after you turn the main
power switch off or you unplug the power cord.
StellaC-AE-CopyF_V4_FM.book Page 8 Wednesday, July 4, 2001 11:21 AM