Radio Shack CD Player - Manual (Page 19)

19
Programming a Sequence
of Tracks
You can program up to 32 selections from 2
discs to play in any order you choose.
Note: Shuffle playback does not work
during program playback.
1. Using your remote control, press
PROGRAM in the stop mode. STEP
01 appears and PROGRAM and the
track number 1 flashes.
2. Press CD or CD-R to select the tray, and
press numeric buttons, or
F
or
J
to
select a track. If you make a mistake,
press the numeric buttons again.
3. Press PROGRAM to store the track into
memory. The next program number
STEP 02 appears.
4. Repeat Steps 2 and 3 to program more
tracks, up to 32 selections. When you
select tracks from the same disc
successively, you do not have to press
CD or CD-R .
Notes:
• If you enter a track number higher than
the highest track on a CD, the CD
recorder ignores the entry.
• If you try to store more than 32
selections, the CD recorder displays
PGM FULL .
• If you press PROGRAM without
selecting a track number, the CD
recorder programs the first track.
• To cancel the program mode, press D
and CLEAR .
5. When you finish the selection of track
numbers, press D. The track number
programmed to
ST: 01 appears.
6. Press g to play the sequence. After the
CD recorder plays all programmed
tracks, it stops and
ST: 01 appears.
The CD recorder keeps the sequence in
memory even after programmed
playback has finished or stopped by
pressing D.
Notes:
• During program playback, press
B
once to return to the beginning of the
current track. To return to the
beginning of the previous track in the
program, press
B
twice. To playback
the next track in the program, press
C
.
• If a program is stored, both g for the
PLAYBACK tray and g/ ENTER for the
RECORD/PLAYBACK tray work to play
the programmed tracks.
Checking/Changing the
Programmed Sequence
In the stop mode, press PROGRAM CHECK .
The CD recorder displays the programmed
sequence's first selection. Each time you
press
PROGRAM CHECK , the CD recorder
displays the next programmed selection.
To change a selection, repeatedly press
PROGRAM CHECK in the stop mode until
the CD recorder displays the track number
you want to change. Enter the desired track
number, then press
PROGRAM .