Plasma rear view / terminal board, Plasma description, Mono) – Runco PL-50XA User Manual
Page 12
11
» Plasma Rear View / Terminal Board
Plasma Description
RGB1
D-SUB
DVI
VIDEO
1
2
3
AUDIO 1
L
(MONO)
R
DVD1/HD1
Y
Cb/Pb
Cr/Pr
AUDIO 2
L
(MONO)
R
DVD2/HD2
RGB2
R
G
Y
B
Cb/Pb
HD
VD
AUDIO 3
L
(MONO)
R
DVD3/HD3
RGB3
D-SUB
EXTERNAL CONTROL
SPEAKERS MUST
HAVE MORE THAN
7WATT RATING
IMPEDANCE 6 OHM
RIGHT
LEFT
AC IN
SPEAKERS MUST
HAVE MORE THAN
7WATT RATING
IMPEDANCE 6 OHM
RIGHT
LEFT
AC IN
A
B
3
D
C
E
F
G
H
I
A AC IN
Connect the included power cord here.
B EXT SPEAKER L and R
Connect speakers (not available from Runco) here. Maintain the correct polarity.
C VIDEO 1,2,3 (BNC, RCA, S-Video)
Connect VCR’s, DVD’s or Video Cameras, etc here. VIDEO1 can be used for INPUT or OUTPUT.
D AUDIO1, AUDIO2, AUDIO3
These are audio input terminals. The input is selectable. Set which video image to distribute them from the audio menu screen.
E DVD1 / HD1
Connect DVD’s, High Definition or Laser Disks, etc here.
F
RGB2, DVD2 / HD2
RGB2: Connect an analog RGB signal and the synchronization signal.
DVD2 / HD2: Connect DVD’s, High Definition sources, Laser Discs, etc. here. This input can be set for use with an RGB or
Component source.
G RGB1 (mini D-Sub 15pin)
Connect an analog RGB signal from a computer, etc. here. This input can be used for Input or Output.
H RGB3, DVD3 /HD3 (DVI 24pin)
Connect a digital signal (TMDS) from a source with a DVI output. This input can be set for use with an RGB3 or DVD3/ HD3
source.
I
EXTERNAL CONTROL (D-Sub)
This terminal is used when operating and controlling the monitor externally by RS-232.