Runco PL-50XA - Manual (Page 4)

IMPORTANT INFORMATION
» Precautions
Please read this manual carefully before using your plasma monitor and keep the manual handy for future reference.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol warns the user that uninsulated voltage within the unit may have sufficient magnitude, it is dangerous to make any kind of
contact with any part inside this unit.
This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included. Therefore,
it should be read carefully in order to avoid any problems.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO DO NOT USE
THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS, UNLESS THE PRONGS
CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH-VOLTAGE COMPONENTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
» Warnings and Safety Precautions
No maintenance other than cleaning is required. Please see the section “Plasma monitor cleaning procedure” on page 5. The plasma
display panel consists of fine picture elements (cells). There may be some cells that do not produce light or remain lit. For operating
safety and to avoid damage to the unit, read carefully and observe the following instructions. To avoid shock and fire hazards:
1. Provide adequate space for ventilation to avoid internal heat build-up. Do not cover rear vents or install the unit in a closed cabinet or
shelves. If you install the unit in an enclosure, make sure there is adequate space at the top of the unit to allow hot air to rise and escape.
If the monitor becomes too hot, the overheat protector will be activated and the monitor will be turned off. If this happens, turn off the
power to the monitor and unplug the power cord. If the room where the monitor is installed is particularly hot, move the monitor to a
cooler location, and wait for 60 minutes to cool the monitor. If the problem persists, contact your dealer for service.
2. Do not use this unit’s polarized plug with extension cords or outlets unless the prongs can be completely inserted.
3. Do not expose the unit to water or moisture.
4. Do not insert any objects, especially metal or liquids, into the Plasma or DHD™ Controller.
5. Do not place the units in direct sunlight, near heaters or in extremely dusty or humid locations.
6. Do not install this system outdoors or otherwise exposed to the elements.
7. Do not place heavy objects on top of the Plasma or DHD™ Controller.
8. Avoid damage to the power cord, and do not attempt to modify the power cord.
9. Unplug the power cord during electrical storms or if the unit will not be used over a long period.
10. Do not open the cabinet which has potentially dangerous high voltage components inside. If the unit is damaged in this way the
warranty will be void. Moreover, there is a serious risk of electric shock.
11. Do not attempt to service or repair the unit. The manufacturer is not liable for any bodily harm or damage caused if unqualified
persons attempt service or open the back cover. Refer all service to authorized Service Centers.
!
3