Runco PL-50XA - Manual (Page 16)

15
(1) ON/OFF
Switches Power ON/OFF. (This does not operate when POWER/STANDBY indicator of the main unit is off.)
(2) IR OUTPUT INDICATOR
Illuminates when a button in pressed, indicating that an IR signal is being transmitted.
(3) ENTER BUTTON
When an item is highlighted on a menu, pressing ENTER will select that item.
(4) CURSOR (▲ / ▼ / ◄ / ►)
Use these buttons to select items or settings and to adjust settings or switch the display patterns.
UP Button: When no menus are present on-screen, the UP button will toggle through aspect ratios in the following order: (RATIO)
Anamorphic → Cinema → VirtualWide → Letterbox → Standard (4:3)
LEFT Button: When no menus are present on-screen, the LEFT button will toggle through the different sources in the following order:
(INPUT) HD Pass Thru 2 → HD Pass Thru1 → DVI 2 → DVI 1 → HD/RGB2 → HD/RGB 1 → Component SD → S-Video 2 →
S-Video 1 → Composite
DOWN Button: When no menus are present on-screen, the RIGHT button will toggle through the different sources in the following
order: (RATIO) Standard (4:3) → Letterbox → VirtualWide → Cinema → Anamorphic
RIGHT Button: When no menus are present on-screen, the RIGHT button will toggle through the different sources in the following
order: (INPUT) Composite → S-Video 1 → S-Video 2 → Component SD → HD/RGB 1 → HD/RGB 2 →DVI 1 → DVI 2 → HD
Pass Thru 1 → HD Pass Thru 2
(5) LIGHT BUTTON
Press this to illuminate the buttons.
(6) MENU BUTTON
Pressing this button will access the OSD (On-Screen Display) controls. Press this button
during the display of the sub-menu to return to the previous menu, or exit the OSD menus.
(7) VIDEO BUTTON
Press this button to select VIDEO (composite video) as the source.
(8) COMP BUTTON
Press this button to select Component SD (480i/576i) input.
(9) DIRECT ACCESS BUTTONS
These red buttons to the right hand-side will allow you direct access to an aspect ratio,
based on the format of the input signal. These buttons are:
ANA - selects Anamorphic (16:9) widescreen aspect ratio
LETBOX - selects Letterbox format aspect ratio
4x3 - selects Standard 4:3 aspect ratio
V-WIDE - selects VirtualWide aspect ratio
(10) S-VID 1 and S-VID 2 BUTTONS
Press this button to select between the S-Video 1 and S-Video 2 inputs.
(11) HD1 and HD2 BUTTONS
Press this button to select between HD1 (High Definition) signal and HD2 signal inputs.
These inputs can auto-detect input signals between YPbPr and RGBHV.
(12) DVI 1 and DVI 2 BUTTONS
Press this button to select between the DVI1 signal and DVI2 signal inputs.
11
6
5
10
9
2
3
1
4
7
8
12
NOTE: If the remote control loses its
‘memory’ as a result of weak or dead
batteries, it must be re-programmed for
the Controller’s code set. To reprogram the
remote to the default IR Code Set, press and
hold the CODE button followed by 1, 7.
DHD ™ Controller Description
» DHD ™ Controller Remote Control