Runco PL-50XA - Manual (Page 9)

8
HOW TO ATTACH OPTIONS TO THE PLASMA MONITOR
You can attach your optional mounts or stand to the plasma monitor in one of the following two ways:
1) While it is upright. (See drawing A)
2) As it is laid down with the screen face down (See drawing B). Lay the protective sheet, which was wrapped around the plasma
monitor when it was packaged, beneath the screen surface so it does not scratch the screen face.
• DO NOT touch or hold the screen face when carrying the unit.
Use only the mounting kit or stand provided by Runco. Refer to mounting kit for detailed instructions.
50 mm (2")
50
mm
(2")
50
mm
(2")
Wall
Wall
50 mm (2")
50 mm (2")
Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding objects
as shown on the diagram to the right when installing.
A
B
• This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (wallmount unit, stand, etc.)
• For correct installation and mounting, it is required to use a trained, Runco Authorized Dealer. Failure to follow correct mounting
procedures could result in damage to the equipment or injury to the installer. Product warranty does not cover damage caused by
improper installation.
How to use the safety metal fittings and the screws for safety
metal fittings
These are fittings for fasting the unit to a wall to prevent tipping
due to external shock when using the stand (optional). Fasten the
safety fittings to the holes in the back of the monitor using the
safety fitting mount screws.