Ricoh LD335c - Manual (Page 41)

Turning On the Power
29
1
Turning Off the Power
AAAA
Make sure the exposure glass cov-
er or the ADF is in the right posi-
tion.
BBBB
Press the operation switch.
The On indicator turns off.
Note
❒ Even if you press the operation
switch, and the indicator does
not turn off, it will blink in the
following cases:
• When the exposure glass cov-
er or ADF is open.
• During communication with
external equipment.
• When the hard disk is active.
Turning Off the Main Power
Important
❒ Do not turn off the main power
switch when the On indicator is lit
or blinking. Doing so may result in
damage to the hard disk or memo-
ry.
❒ Be sure to turn off the main power
switch before pulling out the pow-
er plug. Not doing this may result
in damage to the hard disk or
memory.
AAAA
Make sure the On indicator is not
lit.
BBBB
Open the switch cover, and then
turn off the main power switch.
The main power indicator turns
off.
- - - -When the fax unit (optional) is
installed
When the main power switch is
turned off while using the facsimile
function, waiting fax and print jobs
may be canceled, and incoming fax
documents not received. If you have
to turn off this switch for some rea-
son, follow the procedure below.
Important
❒ Make sure 100% is shown as avail-
able memory on the display before
turning off the main power switch
or unplugging the power cord. Fax
files in memory are deleted an
hour after you turn off the main
power switch or unplug the power
cord. See ”Power Failure Report”,
Facsimile Reference <Advanced Fea-
tures>.
❒ The On indicator will not turn off,
but will blink in dial-in mode even
if you press the operation switch.
When this happens, check the ex-
planations below, and turn off the
main power switch.
• The computer is not controlling
the machine.
• The machine is not receiving a
fax.
JupiterC2_GSG_EN_Pre_FM.book Page 29 Tuesday, December 28, 2004 1:39 PM