Radio Shack CT-354 - Manual (Page 14)

14
If PIN code dialing is set to ON (see “PIN Code
Dialing” on Page 46), the phone displays
PIN
CALL then WAIT FOR PROMPT . Press
again after you hear the tone to send your PIN
code and complete the call.
Notes:
• NO SVC (no service) appears if you are out-
side the cellular service area. See “Signal
Strength.”
• NOT ALLOWED briefly appears if you try to
make a restricted call (see “Selecting a Call
Restriction Level” on Page 26).
3. To end the call, press .
Signal Strength
The vertical bar on the left of the display
shows the strength of the cellular signal
your phone is receiving. The higher the
bar, the stronger the signal.
If the signal strength is low, try moving to
a different location. If you are using the
phone in a building, try moving closer to
a window.
If NO SVC appears, the phone is outside the cellu-
lar service area. This means you cannot make or
receive calls until you move the phone back inside
the cellular service area.
17-1165.fm Page 14 Wednesday, July 21, 1999 2:46 PM