Radio Shack CT-354 - Manual (Page 43)

43
5. If you must dial a number (such as an 800
number) to access the carrier, enter that num-
ber. Then press
. If you do not have to
dial an access number, simply press .
The phone prompts you for the card number
(
CARD ID CODE? ).
Note: To exit without changing the calling card
settings (if you are changing only the access
number, for example), press
.
6. Enter the card number, then press .
The phone briefly displays STORED to confirm
that the selected card information is activated
and stored.
Using a Stored Calling Card Number
Follow these steps to make a call using the calling
card number you stored.
1. Enter the desired area code and phone num-
ber, then hold down until the phone dis-
plays CARD CALL and IN USE . CARD CALL
remains on the display until the access num-
ber is sent to the network, then the phone
prompts you to wait for a dial tone (
WAIT FOR
PROMPT ).
Note: If no calling card is stored in memory,
the phone makes a normal call to the phone
number you entered.
17-1165.fm Page 43 Wednesday, July 21, 1999 2:46 PM