Oasis Concepts Diesel and AC Heating System for Recreational Vehicles and Yachts - Manual (Page 29)

Installing the Fuel System
4.1 Before You Begin
For efficient and safe operation of the Oasis™ Heating Module,
follow all recommendations for properly installing the fuel system.
Any deviations from these must be approved in advance by ITR.
Use only diesel fuel, furnace oil, or stove oil in the Oasis™ Heating
Module. DO NOT USE GASOLINE, CRANKCASE OIL, OR ANY OIL
CONTAINING GASOLINE.
Section
4
! DANGER
Keep fuel lines away from any heat source above 100°F (38°C).
Keep gasoline and any equipment that uses gasoline away from the
Oasis™ Heating Module location. The Oasis™ Heating Module is not
rated for use in an explosive environment.
Never share the fuel supply to the Oasis™ Heating Module with any
other fuel-burning device.
! WARNING
4.2 Fuel System Installation
The fuel pump in the Oasis™ Heating Module has a maximum flow
capacity of 25 GAL/Hr and a maximum pressure of 11.5 psi. A 10
micron fuel filter is recommended. Select a fuel filter based on these
requirements.
Recommendations for Installation
The Oasis™ Heating Module’s fuel connection is accessed from the
top of the heater. The fuel inlet, labelled, is located on the top right
of the Oasis™ Heating Module and consists of a 1/8” NPT threaded
female fitting. The fuel return, labelled, is located next to the fuel
inlet and consists of a 1/8” NPT threaded female fitting. Minimum
International Thermal Research 4-1