Oasis Concepts Diesel and AC Heating System for Recreational Vehicles and Yachts - Manual (Page 57)

Section 8, Operating the Heating Module
• When ON, indicates the space heating zone(s) has faulted.
The specific fault can be identified by examining the
Distribution Module Zone Control Panel (optional) located
beside the Oasis™ Heating Module. There are indicator LED’s
on the panel that indicate the problem. Refer to the
description of the Distribution Module Zone Control Panel for
further details.
8.10 Functions of the Heating Module
Control Panel
• The Oasis™ Heating Module’s Control Panel, Figure 8-2:
Heating Module Main Control Panel, contains three push
buttons: ON/OFF power, Bypass, and Reset. In addition, it
contains nine LED’s indicating Power, AC Heat, Compressor,
Fuel Pump, Combustion Fan, Igniter, Flame Out, Voltage and
Low Water.
Power Button
• The power button turns ON/OFF the power to the control
board. The Power LED (green) turns ON when the power to
the control board is ON.
Bypass Button
• The bypass button is for authorized service personnel
only.
Reset Button
• The reset button when pressed resets the control board.
Power LED (Green)
• The power LED (green) turns ON when the power to the
control board is ON. The LED flashes when the Oasis™
Heating Module is in Bypass mode.
AC Heat LED (Green)
• The AC Heat LED (Green) turns ON when a single or dual AC
immersion element(s) have been activated.
International Thermal Research 8-9