Oasis Concepts Diesel and AC Heating System for Recreational Vehicles and Yachts User Manual
Page 33
Installing Fan Heaters – with
“Distribution Module” Only
5.1 Before You Begin
ITR makes a variety of fan heaters for individual cabins or
areas. There are Cabin heaters and Spacesaver heaters
(where space is limited). These heaters draw as little as 0.9
amps and deliver 140 cfm. These heaters also come in high
output versions and the above numbers are increased by
40%. They should be mounted as close to the floor as
possible. They have a built-in aquastat (optional), which
turns on the fan when the water running through it reaches
120°F (49°C).
The Defrost Heater, provides up to 28,000 BTU/h and uses a
three speed fan, 200/275/450 cfm, 40/55/100 watts.
Note: A limited number of fan heaters can be used
with the Oasis™ Heating and Distribution Modules.
Only the installation of ITR fan heaters is covered in this
Manual.
Section
5
NOTICE
If you are installing non-ITR fan heaters, you must obtain
prior approval from ITR. You must check the fans’ total
amperage draw to ensure they will be compatible with the
Zone Control Board (optional), as well as flow capacity to
ensure that each fan meets system requirements.
International Thermal Research
5-1