Oce North America TCS400 - Manual (Page 7)

Self support tips (GB) 7
What to do when you are not satisfied with
the output quality
Achieve optimal output quality
Introduction
The Océ TCS400 offers 2 methods to check the print quality.
■ Make a quality check print
■
Make a demo print.
On the system information card on the on-line screen of the printer, use the
lower softkey for 'Demo prints' (key 6 on the folded cover) to enter the menu
with the quality check print and the demo print.
Chapter 7 of the user manual includes a section about how to check the print
quality.
When you are not satisfied with the output quality, use the following procedure
1 First, make sure that you load and define the correct media type on the printer.
Use the 'Change media type' wizard, to load a media roll and to change the
media type defined on the system.
Then, make sure you define the correct media type for your job.
The following problems are never connected to media. Ignore the above steps
for these problems and directly continue with step 3. (see ‘Important points for
the sending of print jobs’ on page 15)
■
The length and width measurements are different from the original
■
The coloured lines are not well aligned
■ Missing sections in lines or stepped lines
■ Missing parts of characters
■
Drop-out caused by nozzle problems.
2 Make sure you defined the correct print mode for your job. (see ‘Define the
correct job settings for optimal output quality’ on page 9).