OTC Wireless switch/hub - Manual (Page 14)

4
Equipment Descriptions
ABS / Air Bag 2004 User Guide
Vehicle Adapters
The vehicle adapters are used with the DB 25 power
cable, shown on the previous page. The adapter used
depends on the vehicle being tested. Some of the most
common adapters are shown below.
Note: The Air Bag / ABS software tells you which adapter
must be used for the vehicle you are testing. For details, refer
to “
Step 1: Enter the Vehicle Information ” on page 13 .
Universal “B” Adapter (213486)
Figure 1.6: Universal “B” Adapter
The Universal “B” adapter is for vehicle’s equipped with
Bosch, Teves, or Kelsey Hayes anti-lock brake sys-
tems. The adapter has the following components:
Item 1 8-Pin Connector - connects to the 8-pin connector on
the DB 25 power cable.
Item 2 Leads / Probes - connect to the data link connector
(DLC) of the vehicle’s electronic control unit.
Item 3 Special Leads (not shown) - special, add-on, leads
(216094 and 3305-69) may be required for some
vehicles.
Universal “C” Adapter (3305-74)
Figure 1.7: Universal “C” Adapter
The Universal “C” adapter is for vehicle’s equipped with
Sumitomo anti-lock brake systems. The adapter has
the following components:
Item 1 8-Pin Connector - connects to the 8-pin connector
on the DB 25 power cable.
Item 2 Leads / Probes - connect to the data link connector
(DLC) of the vehicle’s electronic control unit.
Ford II Adapter (3305-58)
Figure 1.8: Ford II Adapter
The Ford II adapter is for vehicle’s equipped with MCU
anti-lock brake systems. It is also for reading Ford EEC-
IV slow codes. The adapter has the following
components:
Item 1 DLC CONNECTOR - connects to the data link
connector (DLC) of the vehicle’s electronic control
unit.
Item 2 8-Pin Connector - connects to the 8-pin connector
on the DB 25 power cable.
1 2
1 2
1
2