OTC Wireless switch/hub - Manual (Page 25)

15
Step 1: Enter the Vehicle Information
ABS / Air Bag 2004 User Guide Chapter 2: Start-up Steps
6 To reuse saved information for a vehicle already tested,
do the following:
a Press the Reuse function key. This displays the
Reuse Vehicles screen, which contains a list of saved
vehicle descriptions.
Figure 2.5: Reuse Vehicles Screen
b Select the vehicle description to use and press the
ENTER key. This displays the illustration of the
required cables, as shown in Step 6.
Note: The Reuse Vehicles list holds 25 vehicle descriptions.
When the list is full, old descriptions automatically delete as
you enter new descriptions. To prevent a description from
being automatically deleted, highlight the description and
press the Save function key. This places a disk icon to the
left of the file name and saves the description until you delete
it. (Use the Delete function key to delete a selected
description.)
7 After you have entered new vehicle information or
selected a vehicle description to reuse, the Required
Cables illustration displays on the Vehicle Identification
screen. With this screen displayed, make the required
cable connections. For specific steps, refer to the next
section (“
Step 2: Connect the Cable ” on page 16 ).
Note: Some vehicles do not have an ECU and do not require
a cable connection. For these vehicles, the screen states that
no cable connection is required. If this happens, skip the next
section and go to “
Step 3: Select the Diagnostic Function ”
on page 18 .
Figure 2.6: Vehicle Information - Required Cables Screen
Note: For some vehicles, this screen will illustrate the vehi-
cle’s Data Link Connector (DLC) test terminals rather than the
required cables.