Onkyo TX-SA705 - Manual (Page 75)

75
Advanced Operations
With the Late Night function, you can reduce the
dynamic range of Dolby Digital, Dolby Digital Plus, and
Dolby TrueHD material so that you can still hear quiet
parts even when listening at low volume levels—ideal
for watching movies late at night when you don’t want to
disturb anyone.
Notes:
• Depending on the design of the contents, there are
some materials that will show no effect even when the
Late Night mode is operating.
• The Late Night function resets to the default when the
AV receiver/AV amplifier is set to Standby.
With the Re-EQ function, you can compensate a
soundtrack whose high-frequency content is too harsh,
making it more suitable for home theater viewing.
This function can be used with the following listening
modes: Dolby Digital, Dolby Digital EX, Dolby Pro
Logic II Movie, Dolby Pro Logic IIx Movie, DTS,
DTS-ES, DTS Neo:6 Cinema, DTS 96/24, THX Cin-
ema, THX Surround EX, THX Select2 Cinema, and
Multichannel.
You can adjust the level of individual speakers during
playback. These adjustments are temporary and will be
cancelled when the AV receiver/AV amplifier is set to
Standby.
Notes:
• You cannot use this function while the AV receiver/
AV amplifier is muted.
• Speakers that are set to No or None in the Speaker
Configuration cannot be adjusted.
Using the Late Night Function
(Dolby Digital, Dolby Digital Plus, and
Dolby TrueHD only)
Press the [RECEIVER] button,
and then press the [L NIGHT] but-
ton repeatedly to select:
Dolby Digital, Dolby Digital Plus:
Off: Late Night function off
(default).
Low: Small reduction in dynamic
range.
High: Big reduction in dynamic
range.
Dolby TrueHD:
Auto: The Late Night function is set
to On or Off automatically
(default).
Off: Late Night function off.
On: Late Night function on.
L NIGHT
CH SEL LEVEL –/+
RECEIVER
Re-EQ
Using the Re-EQ Function
Press the [RECEIVER] REMOTE
MODE button, followed by the
[Re-EQ] button.
Press the [Re-EQ] button again to turn
off the Re-EQ function.
Adjusting Individual Speaker Levels
Press the [RECEIVER] button,
use the [CH SEL] button to select
each speaker, and use the
[LEVEL–] and [LEVEL+] buttons
to adjust the volume.
Speakers are selected in the following
order: Front Left
o Center o Front
Right o Surr Right o Surr Back
Right o Surr Back Left o Surr Left
o Subwoofer.
You can adjust the volume of each
speaker from –12 dB to +12 dB
(–15 dB to +12 dB for the subwoofer)
in 1 dB steps.
The name of the currently selected
speaker and its volume appear on the
display, as shown.